![]() ![]() In order to meet my bandwidth requirement, the video motion capture setting is configured at 720p with a low frame-rate. Again, since DLink has no “home” vs “away” settings, the FTP transfer occurs for all movement in the house regardless of status. Filezilla for mac 13.6 windows#DLink is configured to FTP to send any and all motion detection videos to a designated folder on the same windows laptop.Stringify watches both of our ST presence sensors, when we are both away, it creates an “away” file in a Dropbox location for my primary Windows laptop to indicate the system is “armed”. This is accomplished by a flow in Stringify. When both my wife and I leave, determined by ST iPhone presence sensors, set a flag that the video system is set to away.I didn’t want to do this because of my day job requirements and how often I use Dropbox outside of this solution.Īt a high-level, here is how the solution functions: ![]() The solution can be designed to work without being logged in, but requires additional tweaks to Dropbox to run as a service instead of a local application. This machine is always on, and logged in. Please note, I designed this solution to work on a primary Windows machine on my local network. Google Voice (if you want to send text alerts to more than one person).Please bear in mind I designed this around a Windows home environment - if you’re a Linux/Mac person there are similar tools, but you’ll have to figure that end out: If you want to recreate this project, here is what it requires. I’m happy to say, as of last night, I have successfully completed my project by gluing a lot of different technologies and services together. Filezilla for mac 13.6 1080p#I did not want a perpetual string of 1080p clips being uploaded from my home unnecessarily. After all, the cameras I purchased record in 1080p. The solution should only send video when triggered to preserve both mobile and home bandwidth. ![]() The solution must use the DLink Video Motion area that I drew in the cameras firmware settings as the trigger eventīoth my wife and I must receive a notification with a link to the video that can be accessed from anywhere on our mobile phone to determine whether the alert is a false positive, or an actual threat to home security It needed to use SmartThings presence detectors from my and my wife’s iPhone’s to determine if we were both away to automatically “arm” the video motion solution ![]() So I set out to create my own homegrown solution. After a little research, I also hit a wall trying to use the D-Link Camera Manager SmartApp, Stringify, and IFTTT. Obviously, the DLink Lite app could not provide this feature for me. I really did want to leverage the video monitoring of motion areas and receive notifications only when we were away from the house. Any given weekday would be an insane amount of “Motion Detected” alerts from the DLink app.įor those of you not aware of what I’m talking about, the DLink firmware has this feature where you can draw “motion areas” to monitor for movement: There was no way I was going to leave the alerts on as both me and my wife work from home. Within a few hours, I already had alert fatigue and knew I either had to shut off the notifications, or figure out something else. The app has no ability to differentiate between movement while me and my wife are at home, or if we are away. However, upon installing, I quickly learned the downside of setting the DLink Lite application to send notifications for movement to me. I’m really impressed with the clarity of the video and features of the camera. Over the weekend I purchased two DCS-2630L cameras to allow me to monitor all ground-level entry points in our house. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |